UHLENBROCK POWER 4
Inviato: sabato 2 dicembre 2017, 0:26
Salve, ho acquistato un booster Power 4 della Uhlenbrock da affiancare alla Intellibox 2.
Leggo sul manuale, scaricato da Internet in inglese perchè quello nella confezione è rigorosamente solo in tedesco, la seguente nota:
"Safety Note: If the Power 4 is used with an Intellibox or a Märklin center the ground wires from all transformers that feed boosters and the center must be connected together. If this is not done the booster output of the Intellibox can be destroyed if the track sections which are fed by Intellibox and boosters are mutually cross wired and the separating isolation is bridged."
Vorrei sapere se questo collegamento tra i due alimentatori va fatto comunque o solo in caso di anello di ritorno prtchè sono molto scettico al riguardo.
Se poi qualcuno può anche aiutarmi nella configurazione è senz'altro benvenuto e ringraziato in anticipo.
Leggo sul manuale, scaricato da Internet in inglese perchè quello nella confezione è rigorosamente solo in tedesco, la seguente nota:
"Safety Note: If the Power 4 is used with an Intellibox or a Märklin center the ground wires from all transformers that feed boosters and the center must be connected together. If this is not done the booster output of the Intellibox can be destroyed if the track sections which are fed by Intellibox and boosters are mutually cross wired and the separating isolation is bridged."
Vorrei sapere se questo collegamento tra i due alimentatori va fatto comunque o solo in caso di anello di ritorno prtchè sono molto scettico al riguardo.
Se poi qualcuno può anche aiutarmi nella configurazione è senz'altro benvenuto e ringraziato in anticipo.